GBC SureBind System 1 Spécifications télécharger pdf (Page 5)

4.0 OPERATING INSTRUCTIONS

4.2 Document Assembly

1. Check the bind edge guide alignment by inserting a receiving strip in the strip

recess area. Lay a sheet of correctly aligned punched paper on the strip,

matching up the holes and the strip so that the strip is not showing at the top or

the bottom of the paper. Adjust the bind edge guide if necessary by sliding the

guide to the edge of the paper.

2. Place the back cover (face down), the punched sheets (last page on the bottom),

and front cover (face up) on top of the receiving strip.

3. Place the receiving strip (bottom binding strip with holes), textured side down

in the strip recess, located in front of the backstop. Be sure the small hole in

the receiving strip is over the locating pin. The locating pin is on the left

hand side of the strip recess area in front of the backstop. The locating pin

fits into the small hole in the plastic strip. The strip is positioned correctly

over the locating pin when it is difficult to slide the strip to the right.

Failure to properly align the strip can cause machine damage.

4. Now determine the correct size of the pin strip. Use the scale on the backstop to

determine the thickness of the document and the size of the pins required. Insert

the strip through the document's holes and the receiving strip.

Figure 4-2

4-2

1 2 3 4 5 6

Pas de commentaire

GBC SureBind System 1 Spécifications Page 5