Gbc Usp13 Manuel d'utilisateur télécharger pdf (Page 10)

USP 13 Universal Speed Punch

QUICK REFERENCE INSTRUCTIONS

1. DIE REPLACEMENT

BLOCK UP DIE WITH STICK PROVIDED

LOWER DIE

CLAMP STICK

REMOVE DIE CLAMPS - FRONT & REAR

REMOVE BOTTOM BOLTS

RELEASE CLAMP - RELAX PRESSURE WITH HAND WHEEL

SLIDE DIE OUT

REPLACE DIE WITH STICK IN PLACE

REPLACE BOTTOM BOLTS LOOSELY

ATTACH CLAMPS

TIGHTEN BOLTS

REMOVE STICK

LOWER RAM - TO ALIGN PUNCH PINS

TIGHTEN BOTTOM BOLTS

2. ADJUST BACK RAIL TO DIE BACK GAGE

3. SET PUNCHING DEPTH OF SHORTEST PIN

4. SET BACK JOGGER PULL UP JUST AS LONGEST PUNCH PIN APPEARS

5. SET FRONT STOP TO REAR JOGGER - FRONT STOP COMES TO

FULL UP JUST AS SIDE AND REAR JOGGER START TO MOVE

6. SET REGISTRATION WITH SAMPLE STOCK

7. LOCK FRONT STOP IN PLACE

8. SET SIDE JOGGER TO SLIGHTLY BUCKLE A SHEET OF PAPER.

SET OUTER BELT TO 1/4” OF FULLY JOGGED LIFT

9. SET UP TRANSPORT WHEELS AND BELTS

10. POSITION LONG SMALL ROLLER ASSEMBLY

11. ATTACH SKID STRAPS - END OF STRAPS 1” SHORT OF LEADING

EDGE OF LIFT

12. SET PUSHER SO THAT LEADING EDGE OF LIFT ARRIVES WITHIN

1” FROM FRONT STOP AS IT STOPS IN FULL UP POSITION

13. INSTALL DISKS. ALIGN DISKS WHEN CLAW IS AT 5 O’CLOCK

14. RETRACT KNIFE - LOAD PAPER - ALIGN MATERIAL WITH REAR GUIDE

15. INSTALL STACK GUIDES

16. SET FRONT GUIDE RAIL TO GUIDE LIFT INTO DIE

17. CHECK EVERYTHING FOR TIGHTNESS

18. MAKE FINAL ADJUSTMENT ON RECEIVING TRAY

19. CYCLE MACHINE AND CHECK RESULTS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

Gbc Usp13 Manuel d'utilisateur Page 10